Feeding Application Data Sheet
Please try to provide as much information as possible.
Types of Conveying Systems
being considered
Material Properties
| Material Name: |
|
| Bulk Density: |
(lbs./ft3) |
| Particle Size: |
(in., mm, mesh, micron) |
| Particle Shape: |
Pellet, Powder,
Flake, Curl,
Chip, Lump,
Fibrous, Granular,
Other |
| Material Temperature: |
(deg. F) |
| Max. Temperature Rise: |
(deg. F) |
| Moisture Content: |
(%) |
| Fat Content: |
(%) |
| Flows: |
Well,
Average,
Poor |
| Abrasive: |
High,
Medium,
Low |
| Other Characteristics: |
Hygroscopic,
Sticky, Toxic,
Aerates, Packs,Other
Characteristics: |
| Explosive: |
No or
Yes, if so... K-st
P-max |
| Material Cost: |
(dollars per ton/ pound) |
| Other Characteristics: |
|
System Requirements
| Continuous Feeding (if applicable) |
|
| Maximum Rate: |
(lbs./hr.) |
| Average Rate: |
(lbs./hr.) |
| Minimum Rate: |
(lbs./hr.) |
|
|
| Batch Feeding (if applicable) |
|
| Maximum Batch Size: |
(lbs.) |
| Average Batch Size: |
(lbs.) |
| Minimum Batch Size: |
(lbs.) |
| Product to be Delivered in What Period of
Time: |
|
| Amount of "OFF" Time Before Next
Batch is Required: |
|
|
|
| Hopper Capacity Required: |
Standard,
or Specify(ft3) |
| Accuracy Required: |
(%+/-
Error) |
| Inlet to Outlet Length: |
Standard,
or Specify(in.) |
| Height Restrictions: |
No,
or Specify(in.) |
| Upstream Equipment: |
|
|
Any Temp/Pressure at Feed Inlet: |
No,
or Specify |
| Downstream Equipment: |
|
| Any Temp/Pressure at Feed Discharge: |
No,
or Specify |
| Material Contact: |
Carbon
Steel, 304
SS, 316
SS, Sanitary, or Other
(please specify) |
| Motor Requirements: |
TEFC,
Chem. Duty, Explosion
Proof, or Other |
| Electrical Enclosure Requirements: |
NEMA
12 (dust tight) NEMA
4 (water tight) NEMA
4X (corrosion resistant) NEMA
7/9 (explosion proof) |
| Please Explain Application: |
|
Controller
Project Status
Other Comments
|
